B&B Electronics 3PXCC2a Especificaciones descargar pdf (Pagina 15)

INTERCONNECTING THE EQUIPMENT AE/LZB 119 1894 R1A

OPTION REQUIRED SETTING

RDL REQUEST DENY

LLINE TX POWER

0 DBM (or as required;

use -15 DBM if line loss

is 0 Dbm)

PHONE JACK SINGLE RJ11

MAKE/BREAK RATIO 39% / 61%

SECONDARY CHANNEL DISABLED

PANEL LOCK

UNLOCK (or as required)

SYNC CLOCK

MASTER = CEC/IMC

modem; SLAVE =

console modem

AUTO HANDSHAKE

ORIGINATE = CEC/

IMC modem;

ANSWER = console

modem

LINE TYPE 4LL

4. Access the modem’s ERROR CONTROL submenu

and set each of the following options to the required

setting:

OPTION REQUIRED SETTING

CONTROL LEVEL V.42

FLOW CONTROL DISABLED

NEGOTIA FALLBACK STAYS ON-LINE

BREAK HANDLING DESTRUCTIVE

5. Access the modem’s AUDIO OPTIONS submenu and

set each of the following options to the required setting:

OPTION REQUIRED SETTING

SPEAKER CONTROL ON UNTIL CONNECTED

SPEAKER VOLUME

7 (or as required)

RING VOLUME

7 (or as required)

6. Maintain all modem S registers per default settings

except set S2 = FF and set S35 = 00.

7. Using the modem’s SAVE TO submenu, save this

modem configuration as PROFILE 0. If necessary,

refer to ZyXEL modem user’s manual for specific

instructions.

8. Using the modem’s RESET submenu, set RESET =

PROFILE 0. This causes the modem to initialize with

the PROFILE 0 configuration established in the

previous steps whenever it is powered-up, or reset via a

DTR signal from the PC.

9. Repeat the above configuration for the second modem

in the modem pair.

Refer to Figure 7A and 7B as necessary and/or the

modem manufacturer’s documentation for cable hook-up

and wiring information.

Other Modems

• •

Modem Options

DCE Rate = 9600

Originate/Answer = Originate (CEC/IMC modem)

Originate/Answer = Answer (C3 Maestro modem)

V.32 Fast Train = Enabled

Auto Retrain = Enabled

Internal/External Clock = Internal

Dial-Up/Leased Line = Leased

2-Wire/4-Wire = 4 Wire

TX Level = (as required; use -15 dBm if line loss is 0 dB)

Dial Backup = Manual

Loop Back Time = 15 minutes

Dial Line = RJ11

Line Current Disconnect = Long

Long Space Disconnect = Enabled

V.22 Guard Tone = Disabled

• •

MNP Options

MNP Protocol = Enabled

Auto Fallback = Enabled (or Normal)

Flow Control = CTS Only

XON/XOFF Pass Through = Enabled

Data Compression = Disabled

Inactivity Timer = Off

Break Control = 5

• •

DTE Options

Synchronous/Asynchronous Data = Asynchronous

DTE Rate = 9600

Character Length = 8 Bits

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Comentarios a estos manuales

Sin comentarios

B&B Electronics 3PXCC2a Especificaciones Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Redes B&B Electronics 3PXCC2a