
Intel
®
SRMK2 Internet Server Technical Product Specification 88
Beeps Error message Description
8
Display Memory
Read/Write Error
The system video adapter is either missing or its memory is
faulty. This is not a fatal error.
9 ROM Checksum Error
The ROM checksum value does not match the value encoded
in AMIBIOS.
10
CMOS Shutdown
Register Read/Write
Error
The shutdown register for CMOS RAM has failed.
11
Cache Memory Bad –
Do Not Enable Cache
The cache memory test failed. Cache memory is disabled. Do
not press <Ctrl> <Alt> <Shift> <+> to enable cache memory.
Table 62: BIOS Error Messages
Error Message Description
8042 Gate-A20 Error Gate A20 on the keyboard controller (8042) is not working.
Replace the 8042.
Address Line Short! Error in the address decoding circuitry.
C: Drive Error No response from drive C:. Run the AMIDiag Hard Disk Utility.
Check the C: hard disk type in Standard Setup.
C: Drive Failure No response from hard disk drive C:. Replace the drive.
Cache Memory Bad, Do Not
Enable Cache!
Cache memory is defective. Run AMIDiag.
CH-2 Timer Error An AT system has two timers. There is an error in timer 2.
CMOS Battery State Low CMOS RAM is powered by a battery. The battery power is low.
Replace the battery.
CMOS Checksum Failure CMOS RAM checksum is different than the previous value. Run
WINBIOS Setup.
CMOS System Options Not Set The values stored in CMOS RAM have been destroyed. Run
WINBIOS Setup.
CMOS Display Type Mismatch The video type in CMOS RAM does not match the type detected.
Run WINBIOS Setup.
CMOS Memory Size Mismatch The amount of memory found by AMIBIOS is different than the
amount in CMOS RAM. Run WINBIOS Setup.
CMOS Time and Date Not Set Run Standard Setup to set the date and time.
D: Drive Error No response from drive D:. Run the AMIDiag Hard Disk Utility.
Check the hard disk type in Standard Setup.
D: Drive failure No response from hard disk drive D:. Replace the drive.
Diskette Boot Failure The boot diskette in drive A: cannot be used to boot the system.
Use another boot diskette and follow the screen instructions.
Display Switch Not Proper Some systems require a video switch be set to either color or
monochrome. Turn the system off, set the switch properly, then
power on.
DMA Error Error in the DMA controller.
DMA 1 Error Error in the first DMA channel.
DMA 2 Error Error in the second DMA channel.
FDD Controller Failure AMIBIOS cannot communicate with the floppy disk drive
controller. Check all appropriate connections after the system is
powered down.
Comentarios a estos manuales