B&B Electronics RS-232 to Ethernet Converter ES1A Manual de usuario

Integration with Ethernet and RS-232 Devices Page 1 Integration with Ethernet and RS-232 Devices Revision A

Integration with Ethernet and RS-232 Devices Page 10 One SP device using the web-based setup, but are similar to those for the B & B Elec

Integration with Ethernet and RS-232 Devices Page 11 4. Configure the serial port port profile on the converter device by clicking on the “S

Integration with Ethernet and RS-232 Devices Page 12 5. Configure the serial port parameters by clicking the “Serial Port” option on the lef

Integration with Ethernet and RS-232 Devices Page 13 Scenario 4: Integration with RS-232 Devices Using Custom Integration Commands Overview

Integration with Ethernet and RS-232 Devices Page 14 configuration and management portal. The steps contained in this document are for the D

Integration with Ethernet and RS-232 Devices Page 15 4. Configure the Advanced Network Settings on the Ethernet to RS-232 converter device

Integration with Ethernet and RS-232 Devices Page 16 5. Configure the serial port profile on the converter device by clicking on the “Seria

Integration with Ethernet and RS-232 Devices Page 17 6. Configure the serial port parameters by clicking the “Serial Port” option on the lef

Integration with Ethernet and RS-232 Devices Page 2 Overview HomeWorks QS is a system capable of integrating with other equipment in many wa

Integration with Ethernet and RS-232 Devices Page 3 Scenario 1: Integration with Ethernet Connected Devices Using the Lutron Integration Pro

Integration with Ethernet and RS-232 Devices Page 4 3. Configure the 3rd-party devices and systems to utilize the Lutron Integration Protoco

Integration with Ethernet and RS-232 Devices Page 5 Scenario 2: Integration with Ethernet Connected Devices Using Custom Integration Command

Integration with Ethernet and RS-232 Devices Page 6 If using Telnet, the IP address of the 3rd-party device, Telnet port (default is 23), and

Integration with Ethernet and RS-232 Devices Page 7 4. Assign this command set to the 3rd-party device in the project. This can be chosen f

Integration with Ethernet and RS-232 Devices Page 8 create a state variable with these same states and assign the variable states to the butt

Integration with Ethernet and RS-232 Devices Page 9 Scenario 3: Integration with RS-232 Devices Using the Lutron Integration Protocol Overv