B&B Electronics RS-232 to Ethernet Converter ES1A Manual de usuario descargar pdf (Pagina 3)

Integration with Ethernet and RS-232 Devices Page 3

Scenario 1: Integration with Ethernet Connected Devices

Using the Lutron Integration Protocol

Overview:

In this scenario, integration between HWQS and 3

-party devices is accomplished using an

Ethernet connection and the Lutron Integration Protocol, which is well documented and freely

available. This is the most common type of integration with a HWQS system. Many 3

-party

systems and devices have fully functional two-way integration drivers for HWQS that utilize the

Lutron Integration Protocol and allow for simplified bi-directional integration. The 3

-party

device must open and maintain a Telnet session with the HWQS system.

Equipment Required:

All versions of HWQS software can be used in this scenario. No additional equipment is required

when integrating with Ethernet connected devices using the Lutron Integration Protocol.

Set Up Steps:

1. Configure integration IDs and Telnet logins in the HWQS software. This is accomplished on

the “program” tab under the “configure integration” task in the drop-down menu. A separate

Telnet login must be created for each device. Be sure to enable integration IDs for all the

devices, shades, areas, zones, timeclocks, and HVAC controls that you desire to integrate

with. Everything should be checked by default. If any of these are not checked, they will

not be available through integration. These settings are also used by the Lutron Home

Control+ mobile apps, so do not uncheck anything you would like to access from these apps.

2. Configure the Ethernet connected devices to establish a Telnet session with the HWQS

processor. This is done using the 3

-party device or associated software. Consult that

product’s documentation for details.

1 2 3 4 5 6 7 8 ... 16 17

Sin comentarios

B&B Electronics RS-232 to Ethernet Converter ES1A Manual de usuario Pagina 3