B&B Electronics ESR902 Guía de usuario descargar pdf (Pagina 14)

ES1A Mini Ethernet to RS-232 Converter

B&B Electronics

The ES1A is a serial server that provides

RS-232 to Ethernet conversion and

transport of serial data over an IP

network. The ES1A does not meet the

TS2 temperature specification.

Directions included below may also be

found in the Quick Start Guide and the

User’s Guide along with more detailed

information about the device. Both

documents are shipped with the ES1A

and are available on the B&B Electronics

website at http://www.bb-elec.com.

Cabling

The ES1A has a DB-9 connector on one

end and the RJ-45 Ethernet connector on

the other end. Use the standard serial

cable as described on page 3.

Network Configuration

The ES1A must be setup to ensure the

proper serial port settings are configured

to communicate with the Opticom™

Infrred phase selector over the RS-232

interface and that the proper network

configurations are made to allow the

ES1A to be found on the network by

central management software. The unit

must be configured with a static IP

address.

Turn off automatic IP address using

DHCP.

Specify the IP address to be used by this

device.

Specify the Subnet Mask (usually

255.255.255.0).

Specify the Default Gateway.

Refer to the User’s Guide for instructions

on how to access the configurations via

the internal web pages.

Serial Port Configuration

The serial port configuration consists of

selecting the Serial Port Profile and the

Basic Serial Settings.

The Serial Port Profile specifies the type

of transport communications means

which will be used to ferry the RS-232

serial data over the IP network. Central

management software supports TCP

sockets and RealPort profiles.

Installation of RealPort COM port

redirector software allows the remote

devices to be installed as COM ports on a

PC or server.

Configure the Basic Serial Settings as

described in the Required Serial Settings

on page 3.

Compatibility Test Configuration

Device model: ES1A

Device firmware: 1.9.0.6 Boot: 0.0.0.1

POST: 1.1.3

Comm modes: TCP/IP, redirected serial

Software: Central Management Software

1.5

Phase selector: Opticom Infrared Model

752 / 754

1 2 ... 9 10 11 12 13 14 15

Comentarios a estos manuales

Sin comentarios