B&B Electronics ZP9D-115RM-LR Especificaciones descargar pdf (Pagina 31)

Manual Documentation Number: ZP9D-115RM-LR-0812 31

B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com

B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com

Refer to the „AT Command Mode‟ section for more information regarding the AT

Command Mode Sequence.

CC (Command Sequence

Character) Command

The CC command is used to

set/read the ASCII character

used between guard times of

the AT Command Mode

Sequence (BT + CC + AT).

This sequence enters the

module into AT Command

Mode so that data entering the module (from the host) is recognized as commands

instead of payload.

Refer to the „AT Command Mode‟ section for more information regarding the AT

Command Mode Sequence.

CD (GPO2 Configuration)

Command

<Serial Interfacing> CD

Command is used to

select/read the behavior of the

GPO2 line (pin 3).

AT Command: ATCC

Binary Command: 0x13 (19 decimal)

Parameter Range: 0x20 - 0x7F

Default Parameter Value: 0x2B (ASCII “+”)

Number of bytes returned: 1

Related Commands: AT (Guard Time After), BT

(Guard Time Before)

AT Command: ATCD

Binary Command: 0x28 (40 decimal)

Parameter Range: 0 - 8 (standard rates)

Parameter

Configuration

RX LED

Default High

Default Low

(reserved)

RX LED (valid

address only)

Default Parameter Value: 2

Number of bytes returned: 1

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 53 54

Comentarios a estos manuales

Sin comentarios

B&B Electronics ZP9D-115RM-LR Especificaciones Pagina 31

Comentarios a estos manuales