B&B Electronics ZP9D-115RM-LR Especificaciones descargar pdf (Pagina 23)

Manual Documentation Number: ZP9D-115RM-LR-0812 23

B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com

B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com

Binary Commands

To Send Binary Commands:

Note: CTS (pin 9) is high when a command is being executed. Hardware

flow control must be disabled as CTS will hold off parameter bytes.

Example: Use binary commands to change the RF module's destination address to

0x1A0D and save the new address to non-volatile memory.

RT Command must be set to '1' in AT Command Mode to enable binary

programming.

Assert CMD (Pin 10 is driven high). (Enter Binary Command Mode)

Send Bytes [parameter bytes must be 2 bytes long]:

(Send DT (Destination Address) Command)

(Least significant byte of parameter bytes)

(Most significant byte of parameter bytes)

(Send WR (Write) Command)

De-assert CMD (pin 10 is driven low). (Exit Binary Command Mode)

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 53 54

Sin comentarios

B&B Electronics ZP9D-115RM-LR Especificaciones Pagina 23