B&B Electronics Zlinx ZP Series Especificaciones descargar pdf (Pagina 41)

Manual Documentation Number: ZP24D-250RM-SR-0812 37

B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com

B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com

Returned

Value

(Hex)

Association Indication

0x00

Successful Completion - Coordinator successfully started or End Device association

complete

0x01

Active Scan Timeout

0x02

Active Scan found no PANs

0x03

Active Scan found PAN, but the Coordinator Allow Association bit is not set

0x04

Active Scan found PAN, but Coordinator and End Device are not configured to support

beacons

0x05

Active Scan found PAN, but Coordinator ID (PAN ID) value does not match the ID of the End

Device

0x06

Active Scan found PAN, but Coordinator CH (Channel) value does not match the CH of the

End Device

0x07

Energy Scan Timeout

0x08

Coordinator start request failed

0x09

Coordinator could not start due to Invalid Parameter

0x0A

Coordinator Realignment is in progress

0x0B

Association Request not sent

0x0C

Association Request timed out - no reply was received

0x0D

Association Request had an Invalid Parameter

0x0E

Association Request Channel Access Failure - Request was not transmitted - CCA failure

0x0F

Remote Coordinator did not send an ACK after Association Request was sent

0x10

Remote Coordinator did not reply to the Association Request, but an ACK was received _

after sending the request

0x11

[reserved]

0x12

Sync-Loss - Lost synchronization with a Beaconing Coordinator

0x13

Disassociated - No longer associated to Coordinator

AP (API Enable) Command

<Serial Interfacing> The AP command is

used to

enable the RF module to operate using a

framebased

API instead of using the default

Transparent

(UART) mode.

Refer to the API Operation section when API operation is enabled

(AP = 1 or 2).

AT Command: ATAP

Parameter Range:0 - 2

Parameter

Configuration

Disabled (Transparent

operation)

API enabled

API enabled (with

escaped characters)

Default Parameter Value:0

Minimum Firmware Version Required:

v1.x80

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 69 70

Comentarios a estos manuales

Sin comentarios

B&B Electronics Zlinx ZP Series Especificaciones Pagina 41

Comentarios a estos manuales

Relacionado con productos y manuales para Redes B&B Electronics Zlinx ZP Series