B&B Electronics PC Watchdog Timer Card ATXWDT Especificaciones descargar pdf (Pagina 10)

EP80579 Integrated Processor—Configuration Requirements

Intel

EP80579 Software Drivers for Embedded Applications on FreeBSD*

GSG September 2009

10 Order Number: 320152-005US

2.1.3 Safety

The development board is shipped as an open system allowing for maximum flexibility

in changing hardware configurations and peripherals in a lab environment. Since the

board is not in a protective chassis, the user is required to take safety precautions in

handling and operating the board. Some assembly is required before use.

Ensure a safe and static-free work environment before removing any components from

their anti-static packaging. The development board is susceptible to electrostatic

discharge that may cause failure or unpredictable operation. The development board

must be operated on a flame-retardant surface because a chassis is not included with

the board.

Caution: Connecting the wrong cable or reversing a cable may damage the board and may

damage the device being connected. Since the board is not in a protective chassis, use

caution when connecting cables to the board.

Caution: The power supply cord is the main disconnect device to main power (AC power). The

socket outlet should be installed near the equipment and should be readily accessible.

To avoid shock, ensure that the power cord is connected to a properly wired and

grounded receptacle. Do not connect/disconnect any cables or perform installation/

maintenance of the boards in this product during an electrical storm. Ensure that any

equipment to which this product will be attached is also connected to properly wired

and grounded receptacles.

Note: Ensure that setting up the ATX power supply is the final step performed in the process

of assembly.

2.1.4 Connecting the Serial ATA Hard Drive and Cable

The development board provides two Serial ATA (SATA) connectors. Connect cables to

the appropriate drive sequentially, starting from Port 0 to Port 1. See Figure 2 and

Table 1 for the location and identification of the SATA connectors.

Note: Intel recommends connecting the boot drive to SATA port 0.

2.1.5 Connecting the Keyboard and Mouse

Connect a PS/2 mouse and keyboard to the stacked PS/2 connector on the rear panel

of the board. The bottom connector is the keyboard connector and the top connector is

the mouse connector. Alternatively, a USB keyboard and a USB mouse can be

connected to the development board’s USB connectors.

Note: Mouse and keyboard are not supplied by Intel.

Note: The serial redirection feature can be enabled to remotely access the board through a

serial cable without attaching a keyboard or mouse to the development board. Refer to

the “Connecting the Serial Cable for Console Redirection” section of the Intel

EP80579

Integrated Processor with Intel

QuickAssist Technology Development Kit User’s Guide

for more information.

2.1.6 Connecting the PCI Express Video Card

Populate the PCIe graphics card in any one of the PCIe slots.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Comentarios a estos manuales

Sin comentarios

B&B Electronics PC Watchdog Timer Card ATXWDT Especificaciones Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Redes B&B Electronics PC Watchdog Timer Card ATXWDT