
B&B Electronics, Inc. SPECTRE Configuration Manual
SPECTRE_Configuration_Manual_2912m
www.bb-elec.com
www.bb-europe.com
1.15. IPSec tunnel configuration
Select the IPsec item in the menu to configure an IPsec tunnel. IPsec is a protocol
which is used to create a secure connection between two LANs. Up to 4 IPsec tunnels may
be created.
This item enables the individual tunnels.
This item displays the name of the tunnel specified in the configuration
of the tunnel.
Select to configure an IPsec tunnel.
Table 29: Overview IPsec tunnels
Fig. 32: IPsec tunnels configuration
IP address or domain name of the remote host.
Identification of remote host. The ID contains two parts: a hostname
and a domain-name.
Identification of local host. The ID contains two parts: a hostname and
a domain-name.
Lifetime key data part of tunnel. The minimum value of this parameter
is 60s. The maximum value is 86400 s.
Lifetime key service part of tunnel. The minimum value of this
parameter is 60s. The maximum value is 86400 s.
Specifies the amount of time before the connection will be re-
established. The maximum value must be less than half of the
parameters IKE and Key Lifetime.
Specifies the maximum percentage by which the Rekey Margin should
be randomly increased to randomize re-keying intervals
Defines time after which IPsec tunnel verification occurs
Defines the timeout (in seconds) for a DPD response.
If address translation between two end points of the IPsec tunnel is
used, it needs to allow NAT Traversal
If this parameter is enabled, the IPsec tunnel will be connected faster,
Comentarios a estos manuales